Bhushan Industries, Solapur
Bhushan Industries, Solapur
Chincholi, Solapur, Maharashtra
SEND SMS
SEND EMAIL
 

Detailing

Other

Inhouse Process Plan for your Reference for Machining as per DRG.

  • Check the raw material and allowances for the machining.
  • Set the job on marking table and mark the centre line and machining allowances on the job.
  • Set the job on Lath / Milling / VMC machine by holding it on True ID/OD at both ends within 0.5 to 1 mm.
  • Check the face out and take clean cut.
  • Remove the job and rest the machined face on the chuck.
  • True ID,OD
  • Carry out further machining as per drawing maintaining 2 mm machining allowance all over to the tool point.
  • Take dial reading on machined ID/OD and face of the job. Confirm that readings are within 0.02 TIR.
  • Inspect and record the machined sizes.
  • Check the casting defects all over the job.
  • Mark the defects and rectify them if observed.
  • Prepare the fixture to maintain the concentricity of the job all over.
  • Set the fixture and machine it to take the guide for the size.
  • After Machining the fixture, guide the job on the fixture to ensure the concentricity of the job.
  • Confirm the dial gauge reading after setting the job on the fixture.
  • Finish the job as per drawing.
  • While machining the job from rough stage to finish stage, periodically inspection should be Carried out and maintain the record for each and every job. ( for e.g. concentricity, parallelism, perpendicularity, flatness, surface finish, Sizes, center line, centre distance.)
Reach Us
S. S. Shilwant (Proprietor)
A-34 & W-16, M. I. D. C., Chincholi
Solapur- 413255, Maharashtra, India


Call Us

Send E-mail

Send SMS